作者投稿
专家审稿
编辑办公
Determination of Arizona Test Dust Particle Size Distribution by Malvern Laser Particle Size Analyzer
-
摘要: 马尔文激光粒度仪是常用的测量亚利桑那试验粉尘粒径分布的仪器，采用马尔文激光粒度仪（MS2000）干法和湿法两种方式分别对样品粒度分布进行测试表征。结果发现，对于不同粗细的颗粒物，干法测试结果重复性好，但样品使用量大；湿法测试虽然使用样品量小，但当样品中存在较大粒径颗粒物时，大粒径的颗粒物在溶液中容易沉降，不易混匀，很难被吸进检测器，导致测量结果重复性较差，测试得到的累计粒度分布百分数达到50%所对应的粒径（D50）与干法比较相差较大。通过将A2尘研磨加工，使其粒径分布范围由 1 ~ 100 μm缩小至约为 1 ~ 50 μm，发现湿法测试重复性得到很大改善，与干法相当，且D50也与干法很接近。Abstract: Malvern Laser Particle Size Analyzer is a commonly used instrument to measure the particle size distribution of Arizona test dust. The sample size distribution was characterized by both dry and wet methods using Malvern Mastersizer (MS2000). The results show that for different particle sizes, the dry method results have good repeatability, but the sample was used in a large amount. Although the wet test uses a small amount of sample, when there are large particle sizes in the sample, the large particle sizes tend to settle in the solution and are not easily mixed, making it difficult to be absorbed into the detector, resulting in poor repeatability of the measurement results, and the particle size (D50) corresponding to the cumulative percent size distribution up to 50% of the test obtained was significantly different from that of the dry method. By grinding A2 dust to reduce the particle size distribution from 1～100 μm to 1～50 μm, the repeatability of the wet test was greatly improved and was comparable to that of the dry method, which is close to that of the dry method, including the D50.
-
Key words:
- Arizona dust /
- large particle /
- laser particle size analyzer /
- dry method /
- wet method.
-
图 1 A2试验粉尘湿法测试结果
注：图a、b、c中D50分别为11.26μm、13.87μm和16.88μm；图d为图a、b、c归一化拟合图。
Figure 1. Test results for A2 dust by wet method
图 2 A2试验粉尘干法测试结果
注：图a、b、c中D50分别为6.60μm、6.61μm和6.66μm
Figure 2. Test results for A2 dust by dry method
表 1 实验仪器及材料
Table 1. Experimental equipment and materials
序号 名称 型号 生产厂家 用途 1 行星球磨机 PM100 德国RETSCH 研磨、破碎 2 瓷球 2mm；3mm 德国RETSCH 研磨、破碎 3 马尔文激光粒度仪 MS2000 Malvern Panalytical 样品粒径测试 4 标准筛 300目；500目 绍兴市上虞华丰五金仪器有限公司 筛分样品 
下载: 导出CSV
-
[1] 崔莲. 工业化与城市化进程对大气污染的影响[D]. 上海: 上海社会科学院, 2016. [2] 董如鑫. 环境空气中颗粒物浓度与能见度定量关系研究[D]. 济南: 山东建筑大学, 2014. [3] 黄嫣旻, 束炯, 顾莹. 上海道路扬尘粒径两种分析方法的比较[J]. 华东师范大学学报(自然科学版), 2007(6): 37-43. [4] 赵晓宁, 张国城, 沈正生. 一种应用于激光粉尘仪检定, 校准或测试的"标尺"粒子的制备方法及应用: CN201811568414.9[P]. 2020-06-30. [5] 沈正生, 张国城. 大气颗粒物在线监管技术体系研究[J]. 计量学报, 2010, 31(z1): 51-53. [6] 张国城, 沈正生, 赵红达, 等. 粉尘性质对光散射式粉尘仪测量结果的影响[J]. 计量技术, 2017(7): 46-48. [7] Road vehicles - Test contaminants for filter evaluation - Part 1: Arizona test dust: ISO 12103-1[S]. IX-ISO, 2016. [8] 万真, 张天一, 张志会, 等. 马尔文激光粒度分析仪Mastersizer2000及其应用[J]. 广东化工, 2015, 42(11): 119-120. doi: 10.3969/j.issn.1007-1865.2015.11.057 [9] 霍胜伟, 张国城, 吴丹, 等. 宽分布亚利桑那试验粉尘的制备方法研究[J]. 计量科学与技术, 2021, 65(10): 41-44. doi: 10.12338/j.issn.2096-9015.2020.0295 [10] 戴昊. 光散射法粉尘仪的改进[D]. 南京: 南京理工大学, 2012. [11] 尤帆, 耿向. 筛分法和激光粒度法联合测定陆源碎屑岩粒度[J]. 计量学报, 2021, 42(3): 380-387. doi: 10.3969/j.issn.1000-1158.2021.03.20 [12] 赵蓉旭, 滕令坡, 敖国龙. 用马尔文MS2000激光粒度分析仪测定颜填料粉体粒度[J]. 中国涂料, 2014, 29(3): 64-69. doi: 10.3969/j.issn.1006-2556.2014.03.020 [13] 李华勇, 唐倩玉, 张虎才, 等. MS2000激光粒度仪测量第四纪沉积物粒度的定量进样研究[J]. 海洋地质与第四纪地质, 2020, 184(2): 202-209. [14] 孙丽, 罗婷, 梁蕾. 浅述激光粒度仪的应用[J]. 佛山陶瓷, 2011, 21(1): 37-39. doi: 10.3969/j.issn.1006-8236.2011.01.013 [15] 刘培炎. 激光粒度仪干法和湿法测试在涂料粒径分析中的应用[J]. 涂料工业, 2016, 46(12): 58-62. -
点击查看大图
图(3) / 表(1)
计量
- 文章访问数: 471
- HTML全文浏览量: 206
- PDF下载量: 54
- 被引次数: 0
