激光陀螺测角仪的校准与计量方法

邹伟; 黄垚; 梁可; 朱进; 薛梓

doi:10.12338/j.issn.2096-9015.2021.0598

激光陀螺测角仪的校准与计量方法

doi: 10.12338/j.issn.2096-9015.2021.0598

邹伟^1,,
黄垚^{1, 2},
梁可³,
朱进¹,
薛梓^1, ,

1.
中国计量科学研究院，北京 100029
2.
浙江大学，杭州 310027
3.
航空工业西安飞行自动控制研究所，西安 710076

基金项目: 国家自然科学基金重点项目（51935004）。

详细信息

作者简介:
邹伟（1985-），中国计量科学研究院助理研究员，研究方向：角度计量、视觉测量，邮箱：zouwei@nim.ac.cn

通讯作者:
薛梓（1969-），中国计量科学研究院研究员，研究方向：角度计量，邮箱：xuez@nim.ac.cn

计量
- 文章访问数: 654
- HTML全文浏览量: 369
- PDF下载量: 73
- 被引次数: 0
出版历程
- 网络出版日期: 2022-04-15
- 刊出日期: 2022-06-02

Calibration and Measurement Method of Laser Gyro Goniometer

ZOU Wei^1
,,
HUANG Yao^{1, 2},
LIANG Ke³,
ZHU Jin¹,
XUE Zi^{1
, ,}

1.
National Institute of Metrology, Beijing 100029, China
2.
Zhejiang University, Hangzhou 310027, China
3.
Xi’an Flight Automatic Control Research Institute, Aviation Industry Corporation of China, Xi’an 710076, China

摘要

摘要: 激光陀螺由于零位漂移、溯源等问题导致其无法成为计量标准器，为充分发挥其优越的高精度测角性能，详细介绍了其在计量领域应用，重新定义了更能直观表征激光陀螺测角仪的性能参数，给出了与激光陀螺中“标度因数”、“零漂”相对应的“刻度系数”和“偏置”的定义，通过实验测试了激光陀螺测角仪的刻度系数非线性度、稳定性以及刻度系数温度灵敏度、偏置重复性和偏置温度灵敏度等性能参数，给出了适用于激光陀螺测角仪的校准方法。最后提出了一种去除线性误差的方法，解决激光陀螺测角仪在线计量的溯源问题，通过实验验证因直线拟合误差引入的测角误差小于0.05″，激光陀螺测角仪零起分度误差为±0.5″，可以满足大部分待测仪器的角度校准要求，为测试角位置误差提供了一种有效的在线计量方法。
- 激光陀螺测角仪 /
- 刻度系数 /
- 零位漂移 /
- 偏置 /
- 线性误差
Abstract: Laser gyro can not be used as a metrological standard due to the problems of zero drift and traceability. To give full play to its superior high-precision angle measurement performance, this paper introduces its application in the measurement field in detail, redefines the performance parameters that can characterize the laser gyro goniometer more intuitively, and gives the definitions of “scale factor” and “bias” corresponding to “scale factor” and “zero drift” in the laser gyro. The performance parameters of the laser gyro goniometer, such as scale factor nonlinearity, stability and scale factor temperature sensitivity, scale coefficient temperature sensitivity, bias repeatability, stability and bias temperature sensitivity are tested experimentally, and the calibration method suitable for the laser gyro goniometer is given. Finally, a method to remove the linearity error is proposed to solve the problem of on-line measurement of laser gyro goniometer. The experimental results showed that the angle measurement error introduced by linear fitting error is less than 0.05'', and the zero division error of laser gyro goniometer is ±0.5'', which provides an effective on-line measurement method for measuring angular position error.
- laser gyro goniometer /
- scale factor /
- zero drift /
- bias value /
- linearity error

HTML全文

图 1 刻度系数非线性度标定示意图

Figure 1. Schematic diagram of scale coefficient nonlinearity calibration

下载: 全尺寸图片幻灯片

图 2 刻度系数温度灵敏度标定示意图

Figure 2. Schematic diagram of scale coefficient temperature sensitivity calibration

下载: 全尺寸图片幻灯片

图 3 偏置标定示意图

Figure 3. Schematic diagram of bias calibration

下载: 全尺寸图片幻灯片

图 4 偏置的温度灵敏度标定示意图

Figure 4. Schematic diagram of biased temperature sensitivity calibration

下载: 全尺寸图片幻灯片

图 5 零起分度误差实验装置图

Figure 5. Experimental device of zero division error

下载: 全尺寸图片幻灯片

图 6 零起分度误差实验结果

Figure 6. Experimental results of zero division error

下载: 全尺寸图片幻灯片

图 7 1000次仿真实验数据图

Figure 7. Data chart of 1000 simulation experiments

下载: 全尺寸图片幻灯片

图 8 三轴转台角位置误差在线测量实物图

Figure 8. Online measurement of angular position error of three axis turntable

下载: 全尺寸图片幻灯片

图 9 外框轴角位置测量误差曲线图

Figure 9. Measurement error curve of outer frame axis angular position

下载: 全尺寸图片幻灯片

图 10 中框轴角位置测量误差曲线图

Figure 10. Measurement error curve of middle frame axis angle position

下载: 全尺寸图片幻灯片

图 11 内框轴角位置测量误差曲线图

Figure 11. Measurement error curve of inner frame axis angle position

下载: 全尺寸图片幻灯片

参考文献(20)

[1]	汪之国, 龙兴武, 王飞. 四频差动激光陀螺综述[J]. 2012, 49(4): 34-41.
[2]	黄垚, 薛梓, 乔丹. 光学陀螺测角仪计量性能测试[J]. 计量学报, 2018(38): 61-64.
[3]	PAVLOV P A. A Method for Investigating the Error of a Laser Dynamic Goniometer[J]. Measurement Techniques, 2020, 63(2): 106-110. doi: 10.1007/s11018-020-01757-5
[4]	PAVLOV P A. Laser dynamic goniometer measurement algorithms[J]. Measurement Techniques, 2008, 51(1): 22-27. doi: 10.1007/s11018-008-0005-2
[5]	BACHISH E A, PAVLOV P A. Laser dynamic goniometer metrological characteristics[J]. Measurement Techniques, 2009, 52(5): 465-471. doi: 10.1007/s11018-009-9305-4
[6]	IVSHCHENKO E M, PAVLOV P A. A method of eliminating the influence of magnetic field in a dynamic laser goniometer linear and angular measurements[J]. Measurement Techniques, 2013, 55(10): 1141-1147. doi: 10.1007/s11018-012-0099-4
[7]	PAVLOV P A. A method of reducing the random error of a dynamic laser goniometer[J]. Measurement Techniques, 2008, 51(7): 734-739. doi: 10.1007/s11018-008-9109-y
[8]	BACHISH E A, PAVLOV P A, FILATOV Y V. Development of precision laser goniometer systems[J]. Quantum Electronics, 2013, 43(2): 130-138. doi: 10.1070/QE2013v043n02ABEH015045
[9]	BOHKMAN E, BURNASHEV M, FILATOV Y, et al. Implementation of the dynamic laser goniometer for noncontact measurement of angular movement[J]. Optical Engineering, 2016, 55(7): 074104. doi: 10.1117/1.OE.55.7.074104
[10]	ENO N A, PAVLOV P A, BAGSHAW J T. Investigating the output characteristics of Ring Laser in Laser Dynamic Goniometer[J]. Journal of Physics Conference, 2018, 1124(4): 041041.
[11]	KOPYTOV V V, LIZUNOV V D, NABOKA T V. Investigation of a laser interferometric goniometer[J]. Measurement Techniques, 1996, 39(6): 624-628. doi: 10.1007/BF02369827
[12]	FILATOV Y V, AGAPOY M Y, Bournachev M N, et al. Laser goniometer systems for dynamic calibration of optical encoders[J]. Proceedings of SPIE - The International Society for Optical Engineering, 2003, 5144: 381-481.
[13]	FILATOV Y V, NIKOLAEV M S, PAVLOV P A, et al. Non-contact measurement of an object's angular position by means of laser goniometer[J]. Proceedings of Spie the International Society for Optical Engineering, 2014, 9250: 1-6.
[14]	FILATOV Y V, NIKOLAEV M S, PAVLOV P A, et al. Noncontact measurement of angular position and angular movement by means of laser goniometer[J]. Optical Engineering, 2015, 54(5): 054103. doi: 10.1117/1.OE.54.5.054103
[15]	AGAPOV M Y, BOURNASHEV M N. Errors of measurement by laser goniometer[J]. Infrared Physics & Technology, 2000, 41(2): 97-113.
[16]	BELFI J, BEVERINI N, CARELLI G, et al. G-LAS a ring laser goniometer for angular metrology[C]. Frequency and Time Forum and IEEE International Frequency Control Symposium. IEEE, 2017: 462-465.
[17]	王帆, 黄垚, 杨禹, 等. 单周范围内角速率误差校准[J]. 计量科学与技术, 2021, 65(8): 25-29.
[18]	MOU J, HUANG T, SHU X. Error Analysis and Comparison of the Fiber Optic Gyroscope Scale Factor Obtained by Angular Velocity Method and Angular Increment Method[J]. MAPAN-Journal of Metrology Society of India, 2020, 35(2): 1-13.
[19]	李尕丽, 薛梓, 黄垚, 等. 全圆连续角度装置的系统误差分离与补偿[J]. 仪器仪表学报, 2021, 42(3): 1-9.
[20]	叶文, 蔡晨光, 杨平, 等. 惯性技术计量领域若干问题的思考与展望[J]. 计量科学与技术, 2021, 65(3): 10-15,53.