作者投稿
专家审稿
编辑办公
Equivalent Source Reflection Coefficient and Its Online Measurement Method
-
摘要: 为解决器件不可拆分导致的等效源反射系数无法测量问题，提出了一种基于纹波法原理的等效源反射系数在线测量方法。该方法不需要多根匹配/失配空气线或更复杂的测量器件，仅采用一根匹配空气线和一个失配功率座就能够实现宽频带等效源反射系数在线测量，具有简单高效的优点。推导了稳幅情况下源反射系数和利用功率传递标准时等效源反射系数的表达式，并从失配因子的角度解释了源反射系数中“等效”的含义；分析了失配对于功率比值测量结果的影响，并通过失配因子获得等效源反射系数的在线测量方法。在1~18GHz频段内，以商用功率传递标准作为测试对象对在线测量方法进行了实验验证。结果表明，测量值满足预期指标且符合整体变化趋势，有力验证了该方法的可行性，为开展更宽频带的等效源反射系数在线测量方法研究提供了参考。Abstract: To tackle the inability to measure the equivalent source reflection coefficient due to inseparable components, a new online measurement method for equivalent source reflection coefficient, based on the ripple method, is proposed. This method avoids the need for numerous matched/mismatched airlines or complex measuring devices. Instead, it employs a single matched airline and one mismatched power sensor to conduct a broad frequency band measurement of the equivalent source reflection coefficient, showcasing its simplicity and efficiency. The paper derives the expressions for the source reflection coefficient under amplitude stabilization and the equivalent source reflection coefficient when utilizing a power transfer standard. Furthermore, it elucidates the notion of "equivalence" in the source reflection coefficient from the perspective of the mismatch factor, analyses the effect of mismatch on power ratio measurement results, and proposes an online measurement method for equivalent source reflection coefficient through the mismatch factor. Experiments are conducted on a commercial power transfer standard within the 1-18GHz frequency range. The results meet expected indices and conform to the overall trend, thereby validating the feasibility of this method. The method serves as a reference for further research into wider bandwidth online measurement methods for the equivalent source reflection coefficient.
-
图 3 采用失配空气线组合体结构的等效源反射系数在线测量方法的原理图
Figure 3. Schematic diagram of the online measurement method of equivalent source reflection coefficient using a mismatched airline combination
图 4 采用失配空气线组合体结构的等效源反射系数测量方 法的实验示意图
Figure 4. Experimental setup of the measurement method for the equivalent source reflection coefficient using a mismatched airline combination
图 5 开环条件下，功率与功率比值随频率变化趋势图
Figure 5. Trend of power and power ratio changes with frequency under open loop conditions
图 7 等效源反射系数的在线测量值与厂商相关数值比较
Figure 7. Comparison between online measurement values of the equivalent source reflection coefficient and related values from manufacturer
-
[1] MENG Y S, SHAN Y. Note on handling source mismatch in RF power measurement and metrology[C]. IEEE, 2018. [2] LAI H W, TSUI C M, YANG S L, et al. On propagation of uncertainties through the measurement models of two calibration methods for microwave power splitters[C]. IEEE, 2020. [3] 黎明, 李再奎, 史清林. 定向耦合器与检波器组成等效信号源反射系数的分析[J]. 齐齐哈尔师范学院学报(自然科学版), 1995, 15(2): 15-17. [4] ENGEN G F. Amplitude stabilization of a microwave signal source[J]. IRE Trans Microwave Theory Tech, 1958, MTT-6: 202-206. [5] DING J X, MA S S, YUAN W Z, et. al. A new method for measuring calibration factors of Microwave power transfer standard[C]. IEEE, 2021. [6] DINH D D, LANCASTER M J. Microwave power sensors with integrated filtering function for transfer power standards[J]. IEEE Microwave and Wireless Components Letters, 2020, 30(3): 308-311. [7] 朱军, 李建一, 王增浩. 低反射系数等效信号源的测试方法研究[J]. 中国测试技术, 2008, 34(3): 34-36. [8] RUEFENACHT J, WOLLENSACK M, HOFFMANN J, et al. Practical hints: splitter characterization[R]. METAS, 2015. [9] SHIMAOKA K. A new method for measuring accurate equivalent source reflection coefficient of three-port devices[C]. IEEE, 2018. [10] TOROK A, JANIK D, PEINELT W, et al. Efficient broadband method for equivalent source reflection coefficient measurements[J]. IEEE Trans Instrument & Measurement, 2001, 50(2): 361-366. [11] KIM J H, KANG J S, KWON, J Y, et al. A wide-band method to measure the equivalent reflection coefficient of signal sources[C]. IEEE, 2012. [12] 陈云梅, 杨春涛. 用大失配功率座法测量稳幅环路的等效信号源[J]. 宇航计测技术, 2002, 22(1): 7-12. [13] 方维海, 温鑫, 张璐, 等. 信号源复反射系数测量技术研究[J]. 微波学报, 2014, 30(3): 63-66. [14] 崔孝海, 梁伟军, 赵巍, 等. 微波功率计中校准信号源反射系数测量方法: 201610804858.2[P]. 2017-02-15. [15] 王晋淦. 信号发生器源反射系数的测量方法[J]. 电子测量与仪器学报, 1987, 1(3): 1-10. [16] CUI G Y, LI Y, YUAN W Z, et al. Non-destructive measurement of equivalent source reflection coefficient using a tuner[C]. IEEE, 2022. [17] 张翠翠, 王益, 王建忠. 有源器件端口反射系数测量方法分析[J]. 太赫兹科学与电子信息学报, 2015, 13(2): 267-271. [18] REICHEL T. Procedure for measuring the equivalent reflection coefficient of power splitter[R]. Rohde & Schwarz Munich, 1998 [19] KANG T W, KWON J Y, PARK J I, et al. RF and microwave power standards from 10MHz to 40GHz over decades[J]. Journal of Electromagnetic Engineering and Science, 2018, 18(2): 88-93. [20] BOTELL-REREA M, CROWLEY TP, GARCIA-RUIA I, et al. CENAM's Primary Standard for Microwave power up to 18GHz[C]. IEEE, 2016. [21] RAKONJAC P, MITROVIC Z, MILANOVIC I, et al. Improved method for calibration and nonlinearity correction of microwave power sensor[J]. Tehnicki Vjsenik-thchnical Gazette, 2022, 29(2): 415-427. [22] BOTELLO-REREA M, CROWLEY TP, GARCIA-RUIA I, et al. A 2.4mm coaxial microcalorimeter for use as millimeter-wave power standard at CENAM[J]. IEEE Transaction on Instrument and Measurement, 2021, 70: 1001910. [23] BOTELLO-REREA M, CROWLEY TP, GACIA-RUIA I, et al. CENAM's Primary standard for high frequency power up to 50GHz[C]. IEEE, 2018. [24] BAKTI AN, KWON JY, CHO C, et al. Millimeter-wave power standard transfer systems from 50GHz to 330GHz[C]. IEEE, 2020. [25] GU DZ, LU XF, LAMROZ B, et al. A self-calibrated transfer standard for microwave calorimetry[C]. IEEE, 2018. [26] 苏腾, 郭敏, 刘贵斌, 等. 信号源端口电压驻波比测量方法研究[J]. 计量科学与技术, 2022, 66(7): 33-37. [27] DING N, CUI XH, LI Y, YUAN WZ. Application of Monte Carlo method in uncertainty analysis of mismatch factor[C]. IEEE, 2018. [28] 冯亮, 张露妍. 浅析定向耦合器在中功率计校准中的应用[J]. 仪器仪表标准化与计量, 2014(1): 43-45. -
下载:
点击查看大图
图(8)
计量
- 文章访问数: 221
- HTML全文浏览量: 124
- PDF下载量: 27
- 被引次数: 0
