Research on the Influence of Butterfly Valve on the Onine Calibration Performance of Ultrasonic Flowmeter
-
摘要: 为研究校准现场阻流件对超声流量计的干扰,对蝶阀下游超声流量计内部的流场进行大涡模拟,分析蝶阀开度、流量计流向和周向安装位置对声道上速度分布的影响规律。结果表明,蝶阀造成下游管内速度分布发生严重畸变,且随着超声流量计流向安装距离的增大,流态畸变的干扰作用逐渐减弱,修正系数对周向安装角的敏感度也逐渐下降,最大误差由0.12减小至0.04;超声流量计周向安装位置对其声道上速度分布具有显著影响,修正系数随着周向安装角的变化而波动,且距蝶阀越远,修正系数波动值越小,尤其是周向安装角为0°和180°,修正系数误差均小于0.04;管内流态畸变程度随着蝶阀开度的增大而减小,提高了超声流量计声道上速度分布的均匀性。通过研究,获得了蝶阀扰流条件下超声流量计的推荐安装位置,有助于提高在线校准的准确性。Abstract: In order to reduce the interference of flow obstructions on ultrasonic flowmeter online calibration, a large eddy simulation is performed on the flow field in the ultrasonic flowmeter downstream of the butterfly valve. The effects of the opening degree of the butterfly valve, the flow direction, and the circumferential installation position on the velocity distribution on the sound channel are analyzed. The results indicate that the butterfly valve causes severe distortion of the velocity distribution in the downstream pipe. With the increase of the ultrasonic flowmeter flow direction installation distance, the interference effect of the flow pattern distortion gradually weakens. The sensitivity of the correction coefficient to the circumferential installation angle also gradually decreases, and the maximum difference decreases from 0.12 to 0.04. The circumferential installation position of the ultrasonic flowmeter has a significant impact on the velocity distribution on its sound channel, resulting in fluctuations in the correction coefficient with the change of the circumferential installation angle. Furthermore, the farther away from the butterfly valve, the smaller the fluctuation value of the correction coefficient, especially when the circumferential installation angle is 0° and 180°, and the error of the correction coefficient is less than 0.04. The degree of flow pattern distortion in the pipe decreases with the increase of the butterfly valve opening, which improves the uniformity of the velocity distribution on the sound channel of the ultrasonic flowmeter. The recommended installation position of the ultrasonic flowmeter under the condition of butterfly valve disturbance is obtained, which is helpful in improving the accuracy of the online calibration.
-
Key words:
- metrology /
- ultrasonic flowmeter /
- butterfly valve /
- online calibration /
- numerical simulation /
- velocity distribution
-
-
[1] 窦华, 吴辉, 李月童, 等. 电磁流量计在线校准的可靠性分析[J]. 现代工业经济和信息化, 2020, 194(8): 82-83. [2] 周文辉. 废水监测用流量计在线检测中存在的问题及解决方法[J]. 计量技术, 2020(2): 69-71. [3] 张强. 超声流量计在线校准方法探讨[J]. 中国计量, 2021(3): 117-118. [4] 李长武, 张东飞, 袁明, 等. 液体流量仪表在线校准方法研究[J]. 中国测试, 2009, 35(5): 27-29. [5] 陈 红, 聂西利, 丁渊明. 超声波流量计整流器设计及验证[J]. 自动化仪表, 2018, 39(7): 91-93. [6] 李宁, 向德华, 周艳, 等. 污水排放大口径流量计现场检测技术的研究[J]. 计量技术, 2020(6): 8-11. [7] 郑丹丹, 王蜜, 孙彦招. 速度分布对气体超声流量计声传播规律的影响[J]. 天津大学学报(自然科学与工程技术版), 2017, 50(11): 1169-1175. [8] 陈利琼, 谢虹雅, 孙靖云, 等. 基于CFD的气体超声流量计计量准确性研究[J]. 中国测试, 2019, 45(7): 87-91. doi: 10.11857/j.issn.1674-5124.2018050012 [9] 叶志烜, 薛秀茹, 刘建峰, 等. 蝶阀流场的数值模拟及涡结构分析[J]. 管道技术与设备, 2019(3): 31-35. doi: 10.3969/j.issn.1004-9614.2019.03.010 [10] 吴波, 李晶晶, 李晓鹏, 等. 阀门扰流条件下外夹式与插入式多声道超声流量计性能对比[J]. 计量科学与技术, 2020(8): 34-39. doi: 10.3969/j.issn.1000-0771.2020.08.07 [11] 田顺佳, 戚有龙, 冯春辉, 等. 不同整流器对超声波流量计计量的影响[J]. 油气储运, 2021, 40(7): 780-790. [12] 陈洁, 余诗诗, 李斌, 等. 基于双阈值比较法超声波流量计信号处理[J]. 电子测量与仪器学报, 2013, 27(11): 1024-1033. [13] 沈子文, 徐科军, 方敏, 等. 基于能量变化率的气体超声波流量计信号处理方法[J]. 仪器仪表学报, 2015, 36(9): 2138-2144. doi: 10.3969/j.issn.0254-3087.2015.09.028 [14] 刘永辉, 杜广生, 陶莉莉, 等. 反射装置对超声波流量计水流特性影响的研究[J]. 仪器仪表学报, 2011, 32(5): 1183-1188. [15] 何存富, 刘飞, 张力新, 等. 多声道超声流量计在弯管段安装的适应性研究[J]. 仪器仪表学报, 2011, 32(1): 6-12. [16] 张亮, 孟涛, 王池, 等. 斜插式超声流量计探头插入深度影响实验研究[J]. 仪器仪表学报, 2012, 33(10): 2307-2314. doi: 10.3969/j.issn.0254-3087.2012.10.022 [17] 徐焰栋, 赵作广, 王雪丽, 等. 气体涡轮流量计计量比对中异常值的判别分析[J]. 中国计量, 2022(10): 87-90. [18] F Nicoud, F. Ducros. Subgrid-Scale Stress Modelling Based on the Square of the Velocity Gradient Tensor Flow[J]. Turbulence and Combustion, 1999, 62(3): 183-200. doi: 10.1023/A:1009995426001 [19] 黎荣发, 凌光盛, 赵豪, 等. 低压大流量热式气体质量流量计分流测试方法研究[J]. 计量科学与技术, 2022, 66(8): 3-6,12. [20] 王辉, 刘丁发, 张强. 计量核查技术在气体超声计量系统性能评价中的应用[J]. 计量科学与技术, 2021, 65(4): 68-73,77. [21] 毕晓龙,邢超,吴波,等. 用于液体流量标准装置的便携式时间间隔测试仪的设计与研制[J]. 计量科学与技术, 2022, 66(8): 13-17. [22] 刘发展,赵霖,刘源,等. 基于超声传播时间法的水轮机流量测量不确定度[J]. 计量科学与技术, 2022, 66(2): 33-37, 54. [23] 高峰,李虹杰,刘文艺. 湿度对皂膜流量计计量特性的影响研究[J]. 计量科学与技术, 2021, 65(8): 62-65. [24] 文英杰, 富勇, 蒋志豪, 等. 注射泵自动检定系统设计及流量特性分析[J]. 计量与测试技术, 2022, 49(12): 60-65. [25] 王雪丽, 赵作广, 徐焰栋, 等. 临界流文丘里喷嘴法气体流量标准装置期间核查方法研究[J]. 计量科学与技术, 2023, 67(1): 68-72.